Telecommunication Systems Essay Research Paper Joseph Maria

  • Просмотров 111
  • Скачиваний 5
  • Размер файла 13

Telecommunication Systems Essay, Research Paper Joseph Maria 530 BIS Telecommunication Systems Coursework 2 1) If the noise pulse signal cross the decision level of the detector then an error will occur in the bit value. If the noise is Gaussian there is equal probability for the noise voltage to increase the sample value and to decrease the sample value. Sampling at mid-interval T could result in an error if the noise value is happen to be large. Backward error control is a scheme in which the data is sent coded so that the receiver can detect errors, the receiver requests retransmission of a data block (frame) contain an error. Examples of backward error control code are ARQ (Automatic Request for repeat), BI-QUINARY, GREY CODE. Parity check bit involves the addition of a

single extra bit (the parity bit) to the data. The logic value assigned to the parity bit ensures the number of 1’s in the data block is even if using even parity and odd if odd parity. Cyclic Redundancy Check (CRC): During transmission the serial data stream is passed through a special electronic circuit that generates a frame check sequence (fcs) which is appended to the data. The fcs is actually the remainder that is generated when the electronic circuit divides the data steam by a known polynomial. During reception of the data, the receiver generates a new fcs that is compared with the transmitted fcs. Equality equates to error free transmission; inequality indicates an error but not the location of the error. CRC detects all single bit error, all double bit error, all

burst errors which are less than the fcs length and most other burst errors. The ARQ (Automatic Request for repetition) is a code with standard redundancy. Each character contains seven bits of which only 3 are “1” bits. This gives the code its natural error detecting ability. If the signal arrives contaminated by noise that a code contains ‘mark’-to-‘space’ proportions other than 3:4, an ARQ signal is sent back to the transmitter for the information to be re-transmitted. Forward Error Control such as the Hamming Code detects the presence and location of an error and thus the receiver can correct the data (by inverting the bit). Sufficient redundant bits are added to each block of data to identify and therefore correct errors on receipt. The use of parity can be

extended to two dimensions, in which case it may be possible to locate and correct error. Consider the 7 by 7 data block with row and column parity bits added. 01010000 bold = data 10001011 normal = parity bits 10111011 10001101 00101011 10001000 10100000 11101110 A single error is detected and located and can be corrected. Using even parity, there should be an even number of “1” in each row and column.